Hello everyone!
Its the first time Installing Ubuntu Server on a Power Edge 2950 to me and
The issue is when it comes to partitioning disks, it said it has detected active SATA drives there - "One or more drives containing Serial ATA RAID configurations have been found. Do you wish to activate these RAID devices? Activate Serial ATA RAID devices. I was given two options "yes" or "no". I clicked "Yes" because I thought this would enable ubuntu server to set up RAID1 during the installation. However, I was brought to the Partition disks that says "This is an overview of your currently configured partitions and mount points. Select a partition to modify its settings...., then there are three options to choose namely:
Configure iSCSI volumes
Undo changes to partitions
Finish partitioning and write changes to disk
So I am not sure if I am doing the write thing here. When I chose "Configure iSCSI volumes", I was prompted to choose either Log into iSCSI targets or Finish. I do not know what to do from here.
Any help would be greatly appreciated.
Thank you